1.Noise is understood as the inherent noise of a receiver, which reduces the original signal-to-noise ratio of an input signal.
噪声被理解为接收机的固有噪声（内部噪声），它降低了输入信号的信噪比。
2.It is described a circuit and a method for transforming an input signal into a logical output.
描述了将输入信号转换为逻辑输出的电路和方法。
3.This input stage is always connected to the input signal, not switched at all.
这种投入阶段总是连接到输入信号，而不是切换可言。
4.TRIG LEVEL It chooses a level within signal peak range from which the sweep can be selected at a properly starting edge of the input signal.
触发电平此旋钮在信号峰值范围内选择某一电平，由此可以使扫描选择在输入信号完美开始的边缘。
5.The selected input signal is applied to a proprietary programmable gain front end based around an analog modulator.
选定的输入信号作用于一个以模拟调制器为基础的专有可编程增益前端。
6.input signal does not affect the pressure characteristics of two-way hydraulic lock, but affect the frequency.
仿真结果表明不同的输入流量不影响双向液压锁的压力特性，但影响其频率特性。
7.Stability is property of the system itself and is independent of the input signal.
稳定性是系统本身的属性，与输入信号无关。
8.One is for the balanced input signal, on the rear panel, the second is on the front panel, for the balanced output.
一个是平衡输入信号，在后面板，二是前面板上的平衡输出。
9.The input signal is sampled on the falling edge of CS and the conversion is also initiated at this point.
输入信号在CS的下降沿进行采样，而转换同时在此处启动。
10.the extension length of input signal and sub-band signal only equal to the maximum length of filter banks.
输入信号及子带信号的延拓长度仅需为滤波器组的最大长度。